how to develop an pseudocode read 10 integer from the key board in the range 0 up to 100 and count how many them are larger than 50 and display this result
1. Set a counter variable 'count' to 0
2. Repeat 10 times:
a. Prompt the user to enter an integer
b. Read the integer from the keyboard and store it in a variable 'num'
c. If 'num' is greater than 50:
i. Increment 'count' by 1
d. If 'num' is not within the range of 0 to 100:
i. Display an error message and prompt the user to enter another integer
3. Display the value of 'count' to the user as the number of integers greater than 50.
End program.
Pseudocode:
```
count = 0
for i = 1 to 10 do:
print "Enter an integer between 0 and 100: "
num = read integer from keyboard
if num > 50 then:
count = count + 1
else if num < 0 or num > 100 then:
print "Error: Integer must be within the range of 0 to 100."
print "Please enter another integer: "
num = read integer from keyboard
print "Number of integers greater than 50: ", count
```
how to develop a algorithm read 10 integer from the keyboard in the range of 0 up to 100 and count how many the are larger than 50 and display this sum
1. Set a variable 'count' to 0.
2. Repeat 10 times:
a. Prompt the user to enter an integer.
b. Read the integer from the keyboard and store it in a variable 'num'.
c. If 'num' is greater than 50, add 1 to 'count'.
d. If 'num' is not within the range of 0 to 100, display an error message and go back to step 2a.
3. Display the value of 'count' to the user as the number of integers greater than 50.
4. End the program.
Algorithm:
```
count = 0
for i = 1 to 10 do:
display "Enter an integer between 0 and 100:"
num = read integer from keyboard
if num > 50 then:
count = count + 1
else if num < 0 or num > 100 then:
display "Error: Integer must be within the range of 0 to 100."
i = i - 1
display "Number of integers greater than 50: ", count
```
Note: The algorithm assumes that the user will enter integers only, if the user enters a non-integer value it may cause errors.
Here's a step-by-step guide on how to develop pseudocode for reading 10 integers from the keyboard, checking if they are larger than 50, and displaying the count of numbers that satisfy the condition:
1. Initialize a variable `count` to 0.
2. Create a loop that runs 10 times to get 10 integers from the keyboard.
3. Inside the loop, read an integer value from the keyboard and store it in a variable, let's call it `num`.
4. Check if `num` is greater than 50:
- If `num > 50`, increment the `count` variable by 1.
5. Repeat steps 3 and 4 for the next 9 integers.
6. Display the value of the `count` variable, which will represent the number of integers greater than 50.
Here's the pseudocode representation:
```
Step 1: Set count to 0
Step 2: Repeat 10 times
Step 3: Read an integer from the keyboard and store it in num
Step 4: If num > 50, increment count by 1
End Repeat
Step 5: Display the value of count
```
Keep in mind that pseudocode is not a specific programming language, but a way to express the logic of an algorithm in simple steps. You can use this pseudocode as a guideline to implement your algorithm in your preferred programming language.