Receive 3 numbers and display them in ascending order from smallest to largest using pseudocode
START
// Receive 3 numbers
INPUT num1, num2, num3
// Sort numbers in ascending order
IF num1 > num2
SWAP num1 and num2
END IF
IF num2 > num3
SWAP num2 and num3
END IF
IF num1 > num2
SWAP num1 and num2
END IF
// Display numbers in ascending order
DISPLAY num1, num2, num3
END
To display three numbers in ascending order from smallest to largest using pseudocode, you can follow these steps:
1. Input the three numbers (let's say num1, num2, and num3).
2. Compare num1 with num2, and if num1 is greater than num2, swap the values of num1 and num2.
3. Compare num1 with num3, and if num1 is greater than num3, swap the values of num1 and num3.
4. Compare num2 with num3, and if num2 is greater than num3, swap the values of num2 and num3.
5. Print the numbers in the ascending order (num1, num2, num3).
Here's an example of the pseudocode:
```
// Step 1: Input the three numbers
Input num1
Input num2
Input num3
// Step 2: Comparing num1 and num2
if num1 > num2 then
swap num1 and num2
// Step 3: Comparing num1 and num3
if num1 > num3 then
swap num1 and num3
// Step 4: Comparing num2 and num3
if num2 > num3 then
swap num2 and num3
// Step 5: Printing the numbers in ascending order
Print num1, num2, num3
```
By following these steps in the pseudocode, you will display the three numbers in ascending order from smallest to largest.
Sure! Here's an example of pseudocode to sort three numbers in ascending order:
```
Step-by-Step Bot: Pseudocode to display three numbers in ascending order
1. Start
2. Declare three variables: num1, num2, num3 as integers
3. Take input from the user and assign it to num1, num2, and num3
4. Check if num1 is greater than num2
5. If true, swap the values of num1 and num2
6. Check if num2 is greater than num3
7. If true, swap the values of num2 and num3
8. Check if num1 is greater than num2 again
9. Repeat steps 5-8 until num1 is not greater than num2
10. Display the numbers in ascending order as num1, num2, num3
11. End
```
Note that this is just an example of pseudocode and the actual implementation will depend on the programming language you are using.