Ask questions and get helpful answers.
Ask a New Question
  1. Questions
  2. lab....

when doing a lab you need an anayliss, but what is it and how do I make it like what do I need to put into my analysis?

In the "analysis" part of a scientific experiment, you take the data you have collected and use it to answer whatever question or problem was the objective of the experiment. It should include an error analysis.

  1. 👍
  2. 👎
  3. 👁
  4. ℹ️
  5. 🚩
adam

Answer this Question

Related Questions

  1. Electrochemistry

    In lab, we did an experiment with electrochemical cells with solutions of ZnSO4, CuSO4, Al2(SO4)3 and MgSO4 and their respective metal electrodes. There are a couple of post-lab questions that I'm not sure about: (1) Summarize Part A with a data table

  2. Chemistry

    For an enthalpy lab, why would calculated value differ from the theoretical value (in percent error) for the heat reaction of Mg/HCl and MgO/HCl

  3. math

    A lab needs a 20 liters of a 15% acid solution. The lab only has a 10% acid solution and a 30% acid solution. How much of the 10% acid solution will they need to mix with the 30% solution to obtain 20 liters of a 15% solution?

  4. chemistry

    the student's lab manual says to mix some of his CaCl2 solution with an aqueous solution of sodium carbonate (Na2CO3). What evidence of a chemical reaction would he expect to see?

  5. chem

    what is the difference between a bunsen burner and a lab burner?

  6. physics

    In lab you submerge 100 g of 41 degree Celcius iron nails in 100 g of 25 degree Celcius water (the specific heat of iron is 0.12 cal/g degrees Celcius) A)Equate the heat gained by the water to the heat lost by the nails and find the final temperature of

  7. Chemistry

    How would you distinguish between calcium hydrogen carbonate and sodium hydrogen carbonate without using any lab chemical

  8. Chemistry

    Starting with copper metal describe how a sample of crystals of copper (ii)chloride may be prepared in the lab

  9. chem

    Okay so Im doing a lab on preparation of K3[Fe(C2O4)3]*3H2O The final weight I got 2.835g. How can I find the theoretical yield of this? What do I need?

  10. Chemistry

    You are asked to go into the lab and prepare an acetic acid-sodium acetate buffer solution with a pH of 5.43 ± 0.02. What molar ratio of CH3COOH to CH3COONa should be used?

Still need help?

You can ask a new question or browse existing questions.