As shown in the figure, a block of mass M1 = 0.470 kg is initially at rest on a slab of mass M2 = 0.850 kg, and the slab is initially at rest on a level table. A string of negligible mass is connected to the slab, runs over a frictionless pulley on the edge of the table, and is attached to a hanging mass M3. The block rests on the slab but is not tied to the string, so friction provides the only horizontal force on the block. The slab has a coefficient of kinetic friction ìk = 0.330 and a coefficient of static friction ìs = 0.570 with both the table and the block. When released, M3 pulls on the string and accelerates the slab, which accelerates the block. Find the maximum mass of M3 that allows the block to accelerate with the slab, without sliding on top of the slab.
 👍
 👎
 👁
 ℹ️
 🚩
Answer this Question
Related Questions

physics
A block is at rest on the incline shown in the figure. The coefficients of static and ki netic friction are μs = 0.45 and μk = 0.38, respectively. The acceleration of gravity is 9.8 m/s2 . What is the frictional force acting on the 25 kg mass? Answer in

physics
A block of mass m = 5.4 kg is pulled up a θ = 24° incline as in the figure with a force of magnitude F = 35 N. (a) Find the acceleration of the block if the incline is frictionless. m/s2 (b) Find the acceleration of the block if the coefficient of

Physics
A block of mass M resting on a 21.5° slope is shown. The block has coefficients of friction μs=0.605 and μk=0.344 with the surface. It is connected via a massless string over a massless, frictionless pulley to a hanging block of mass 2.57 kg. What is

Physics
A contestant in a winter games event pushes a 59.0 kg block of ice across a frozen lake as shown in the figure below. The coefficient of static friction is 0.1 and the coefficient of kinetic friction is 0.03. The block is being pushed at a direction of 23

Physics (6)
A 10g bullet moving 1000 m/s strikes and passes through a 2.0kg block initially at rest, as shown. The bullet emerges from the block with a speed of 400 m/s. To what maximum height will the block rise above its initial position?

Physics
Block 1, of mass m1 = 0.650kg , is connected over an ideal (massless and frictionless) pulley to block 2, of mass m2, as shown. For an angle of θ = 30.0∘ and a coefficient of kinetic friction between block 2 and the plane of μ = 0.400, an acceleration

physics
A 3.0kg block sits on top of a 5.0kg block which is on a horizontal surface. The 5.0kg block is pulled to the right with a force as shown in the figure . The coefficient of static friction between all surfaces is 0.65 and the kinetic coefficient is 0.42.

Physic
The figure below shows a block of mass m resting on a 20¡ã slope. The block has coefficients of friction ¦Ìs = 0.73 and ¦Ìk = 0.53 with the surface. It is connected via a massless string over a massless, frictionless pulley to a hanging block of mass

Physics
In Case A the mass of each block is 4.8 kg. In Case B the mass of block 1 (the block behind) is 9.6 kg, and the mass of block 2 is 4.8 kg. No frictional force acts on block 1 in either Case A or Case B. However, a kinetic frictional force of 9.4 N does act

physics
Part 1) The block in the figure is initially at rest on an inclined plane at the equilibrium position that it would have if there were no friction between the block and the plane. How much work is required to move the block 50 cm down the plane if the

Physics (Algebrabased)
A block starts at rest and slides down a frictionless track except for a small rough area on a horizontal section of the track.It leaves the track horizontally, flies through the air, and subsequently strikes the ground. gravity= 9.81 m/s^2.

Physics
1. The figure shows a 100kg block being released from rest from a height of 1.0 m. It then takes 0.53 s for it to reach the floor. What is the mass m of the block on the left? There is no friction or mass in the pulley, and the connecting rope is very

Physics
A block of mass m = 2.00 kg is released from rest h = 0.500 m from the surface of a table, at the top of a theta = 30.0° incline. The frictionless incline is fixed on a table of height H = 2.00 m. (a) Determine the acceleration of the block as it slides

Physics
Block B in the figure(Figure 1) rests on a surface for which the static and kinetic coefficients of friction are 0.65 and 0.40, respectively. The ropes are massless.What is the maximum mass of block A for which the system is in equilibrium? (Consider the

physics
A block of mass M rests on a block of mass M1 = 5.00 kg which is on a tabletop. A light string passes over a frictionless peg and connects the blocks. The coefficient of kinetic friction mk at both surfaces equals 0.330. A force of 60.0 N pulls the upper

Physics
The block shown in (Figure 1) has mass m = 7.0 kg and lies on a fixed smooth frictionless plane tilted at an angle θ = 22.0 ∘ to the horizontal. If the block starts from rest 15.2 m up the plane from its base, what will be the block's speed when it

physics
A 3.90 kg block located on a horizontal frictionless floor is pulled by a cord that exerts a force F=14.1N at an angle theta=32.5degrees above the horizontal, as shown. a.) What is the magnitude of the acceleration of the block when the force is applied?

Physics
A block of mass 3m is placed on a frictionless horizontal surface, and a second block of mass m is placed on top of the first block. The surfaces of the blocks are rough. A constant force of magnitude F is applied to the first block as shown in the figure.

physics
Two boxes are connected by a weightless cord running over a very light frictionless pulley as shown in the figure. Box A, of mass 8.0 kg, is initially at rest on the top of the table. The coefficient of kinetic friction between box A and the table is 0.10.

physics
A 4kg block is lowered down a 37° incline a distance of 5m from point A to point B. A horizontal force (F = 10 N) is applied to the block between A and B as shown in the figure. The kinetic energy of the block at A is 10 J and at B it is 20 J. How much
Still need help?
You can ask a new question or browse existing questions.