What should you do if you get chemicals into your eyes in a laboratory?(1 point)
Locate and use an eye/face wash.***
Wipe the chemicals off your face.
Put on safety goggles.
Go home and take a shower
Your right
B A D D A is correct. i got a 100
D A B B C is correct
what are the answers other than the letters brodas
To properly handle the situation if you get chemicals into your eyes in a laboratory, you should locate and use an eye/face wash. This is the correct and most effective action to take to quickly and thoroughly rinse the chemicals out of your eyes.
To find the eye/face wash, you can look for it near sinks or in specific emergency eyewash stations that are typically present in laboratories. It is important to be familiar with the location of these stations before starting any experiments.
Once you have located the eye/face wash, follow these steps:
1. Immediately position yourself in front of the eye/face wash station.
2. Use your clean hand to hold your eyelids open.
3. Activate the eye/face wash by pulling the lever or pressing the button.
4. Allow the water to flow continuously over your eyes for at least 15 minutes, ensuring that the water reaches every part of your eyes, including the inner corners.
5. While rinsing, you can gently rotate your eyeballs to help flush out the chemicals.
6. Avoid rubbing your eyes as this may worsen the irritation or cause further damage.
7. If necessary, seek medical attention after rinsing your eyes.
Remember, it is important to prioritize safety in the laboratory and always wear appropriate protective eyewear, such as safety goggles, to prevent chemical exposure to your eyes.
C
A
A
D
C
Are those correct?