Ask questions and get helpful answers.
Ask a New Question
  1. Questions
  2. physics

Water is flowing in a pipe with a circular cross-section area ,and at all point the water completely fills the pipe.At point 1 ,the cross sectiona are of pipe is 0.070 meter square and the fluid velocity is 3.50 meter per second.

a.) what is the fluid speed at point in the pipe where the cross-sectional area is 0.105 meter square?
b.) Calculate the volume of the water discharge from the open end of the pine in 1000 hour.

  1. 👍
  2. 👎
  3. 👁
  4. ℹ️
  5. 🚩
cathrena
1 answer

  1. Law of continuity: Mass rate in = mass rate out, or
    Area1*density1*Velocity1=area2*velocity2*density2

    densities are equal, so
    .07m^2*3.5m/sec=.105m^2*V solve for velocity V

    volume/hr=V*3600sec/hr
    in 1000 hrs, multiply that by 1000

    1. 👍
    2. 👎
    3. ℹ️
    4. 🚩
    👤
    bobpursley

Answer this Question

Similar Questions

  1. Calculus

    Find the volume of the solid whose base is the circle x^2+y^2=64 and the cross sections perpendicular to the x-axis are triangles whose height and base are equal. Find the area of the vertical cross section A at the level x=7.

  2. Calculus

    Find the volume of the solid whose base is the circle x^2+y^2=25 and the cross sections perpendicular to the x-axis are triangles whose height and base are equal. Find the area of the vertical cross section A at the level x=1.

  3. Calculus

    A gutter with trapezoidal cross-section is to be made from a long sheet of stainless steel that is 30 cm wide by turning up one-fourth of the width on each side. What width across the top will give the maximum cross sectional area?

  4. Physics

    Water flows into one end of a horizontal, cylindrical pipe at 2.0 m/s. The pipe then narrows until its diameter at the opposite end is only 1/3 of that at the beginning. (a) What is the flow speed at the narrow end of the pipe? (b) What is the pressure

  5. Physics

    An incompressible fluid is flowing through a horizontal pipe with a constriction. The velocity of the fluid in the wide section of the pipe is 4.00 m/s and the velocity of the fluid in the narrow section of pipe is 9.00 m/s. The pressure of the fluid in

  6. Physics

    Please someone help..A horizontal pipe 10.0cm in diameter has a smooth reduction to a pipe 5.0cm in diameter. If the pressure of the water in the large pipe is 80000Pa and the pressure in the small pipe is 60000Pa at what rate does water flow through the

  7. physics

    The pressure in a section of horizontal pipe with a diameter of 2 cm is 143 kPa. Water flows through the pipe at 2.80 L/ s. If the pressure at a certain point is to be reduced to 103 kPa by constricting a section of the pipe, what should the diameter of

  8. physics

    Water moves through a constricted pipe in steady, ideal flow. At the lower point shown in figure below, the pressure is P1 = 1.75X104 Pa and the pipe diameter is 6.00 cm. At another point y = 0.250 m higher, the pressure is P2 = 1.20X104 Pa and the pipe

  9. geometry

    The area A of a cross section through the center of a sphere is 32in^2. Find the surface area of the sphere.

  10. Physics

    A man which travel due north in other to cross a river 5km wide flowing due east at 3km/h. If he can roll at 10km/h in still water. Find either by scale drawing or by calculation (1) the direction in which he must head is boat in order to get to his

Still need help?

You can ask a new question or browse existing questions.