explain how you would obtain solid lead carbonate from a mixture of lead carbonate and sodium carbonate powder

Add water, Na2CO3 dissolves, filter, PbCO3 stays in the paper and dissolved Na2CO3 goes through as the solution. Dry the PbCO3 and you have the dry solid.

Add water to dissolve then filter to obtain PbCo3 as you're residue and Na2Co3 as the filtrate. Dry the insoluble PbCo3 between filter papers and you obtain solid PbCo3

Add water to the mixture .Sodium carbonate will dissolve while lead carbonate will not .Then filter the mixture to obtain sodium carbonate as the filtrate and lead carbonate as the residue.Heat the filtrate to saturation to obtain crystals of sodium carbonate.

Your answer is quite confusing to form 2 beginners

Quite confusing to form two starters

Add water to the mixture of lead carbonate and sodium carbonate powder. Filter the mixture, sodium carbonate powder dissolves in water and lead carbonate does not. Lead carbonate will remain as residue while sodium carbonate as filtrate. Heat the filtrate and use glass beads to confirm the formation of crystals of solid carbonate.

To obtain solid lead carbonate from a mixture of lead carbonate and sodium carbonate powder, you can use the process of precipitation. Here's a step-by-step explanation of how to do it:

1. Prepare a solution: Dissolve the mixture of lead carbonate and sodium carbonate powder in water. Choose an appropriate amount of water to ensure complete dissolution.

2. Precipitation reaction: Add a solution of a suitable lead salt, such as lead nitrate (Pb(NO3)2), to the mixture solution from step 1. This will result in a precipitation reaction.

3. Filter the precipitate: After the precipitation reaction, a solid lead carbonate precipitate will form in the solution. Use a filter paper or other filtration method to separate the solid precipitate from the liquid.

4. Wash the precipitate: Rinse the solid precipitate with distilled water to remove any impurities or remaining soluble salts. Continue washing until the water used for rinsing becomes clear.

5. Dry the precipitate: Place the washed precipitate in an oven or any suitable drying equipment to remove any residual water. Allow it to dry completely.

By following these steps, you can obtain solid lead carbonate from the mixture of lead carbonate and sodium carbonate powder. It's important to note that safety precautions should be taken when handling chemicals, and it's advisable to consult proper lab procedures and guidelines, as well as any regulatory requirements, before performing experiments.

Yes

by use of fractional distollation